BQQXB - SUPER LATEX FLAT WALL PAINT ALL COLORS, 550

  • MSDS: BQQXB
  • Manufacturer: KELLY MOORE PAINT CO INC
  • Product Name: SUPER LATEX FLAT WALL PAINT ALL COLORS, 550
  • National Stock Number: 8010-00N036377
Product Identification

Product ID:SUPER LATEX FLAT WALL PAINT ALL COLORS, 550
MSDS Date:05/30/1986
FSC:8010
NIIN:00N036377
MSDS Number: BQQXB

Responsible Party
KELLY-MOORE PAINT CO INC
1015 COMMERCIAL ST
SAN CARLOS, CA 94070
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 415-592-8337

Preparer: JOE SCARRY

Cage: KELLY

Contractor
KELLY-MOORE PAINT CO INC
SAN CARLOS, CA 94070 US

Telephone: 415-592-8337

Cage: KELLY

Ingredients

PROPIONIC ACID, 2-METHYL-, MONOESTER WITH

CAS: 25265-77-4

RTECS: UF6000000

Fraction By Weight: <5%


MAY CONTAIN PIGMENTS (INGS 4 - 8) THAT MAY BE NUISANCE DUST

RTECS: 9999999ZZ


TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293


SILICATES

CAS: 14407-96-6


CALCIUM CARBONATE; (MARBLE), (LIMESTONE)

CAS: 1317-65-3

RTECS: EV9580000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST


SILICON DIOXIDE (AMORPHOUS)

CAS: 67762-90-7


BARIUM METABORATE MONOHYDRATE

CAS: 13701-59-2


PHENYLMERCURIC ACETATE; (PAINT PRESERVATIVE) (SARA

CAS: 62-38-4

RTECS: OV6475000

OSHA PEL 0.1 MG/M3 (HG), C, S

ACGIH TLV: 0.01 MG/M3 (HG)

EPA Report Quantity: 100 LBS

DOT Report Quantity: 100 LBS


3,5,7-TRIAZA-1-AZONIAADAMANTANE, 1-(3-CHLOROALLYL)-,

CAS: 4080-31-3

RTECS: XX8450000


0.1 @ 68F.

CAS: 107-21-1

RTECS: KW2975000

Fraction By Weight: <5%

OSHA PEL 50 PPM, C

ACGIH TLV: 50 PPM, VAPOR, C

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:DIZZINESS, HEADACHE, NAUSEA,
CONFUSION, IRRITATION TO UPPER RESPIRATORY TRACT, UNCONSCIOUSNESS,
SKIN & EYE IRRITATION. CHRONIC:NONE KNOWN.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:SEE YOUR MD FOR SPECIFIC MEDICAL
OPINION REGARDING YOUR CONDITION.

First Aid

First Aid:INHAL:REMOVE TO FRESH AIR. RESTORE BREATHING. CONSULT MD.
EYE:FLUSH W/LARGE VOLUMES OF WATER FOR AT LEAST 15 MINUTES. GET
MEDICAL ATTENTION. SKIN:WIPE OFF W/RAG. WASH THOROUGHLY W/SOAP &
WATER. INGEST :CONSULT HOSPITAL, EMERGENCY ROOM OR POISON CONTROL
CENTER IMMEDIATELY.

Fire Fighting

Flash Point:>200F,>93C
Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE (DUE TO
BUILD-UP OF STEAM PRESSURE) WHEN EXPOSED TO EXTREME HEAT.

Accidental Release

Spill Release Procedures:VENTILATE AREA TO PREVENT BUILD-UP OF VAPORS.
FOR SMALL SPILLS, SOAK UP W/ABSORBENT. FOR LARGER SPILLS, DIKE AREA
W/ABSORBENT MATERIAL & SCOOP UP LIQUIDS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS
AWAY FROM HEAT & FLAME.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Exposure Controls

Respiratory Protection:USE NIOSH/MSHA APPRVD PARTICLE MASK TO AVOID
BRTHG SPRAY MIST/SANDING DUST IF LOC VENT IS ADEQ TO KEEP TLV W/IN
ACCEPT LIMS. IF LOC VENT IS NOT ADEQ, THE USE OF NIOSH/MSHA APPRVD
RESP FOR ORG VAP, SUP PLIED AIR/SCBA EQUIP IS RECOM.
Ventilation:LOCAL EXHAUST SUFFICIENT TO KEEP TLV BELOW PRESCRIBED
LIMITS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:REMOVE & WASH CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Chemical Properties

HCC:N1
Boiling Pt:B.P. Text:212F,100C
Vapor Pres:SEE INGS
Vapor Density:LTR/AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:60-70

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED TO DECOMPOSITION AS IN WELDING.

Disposal

Waste Disposal Methods:DISCARD IN LANDFILL IN SEALED METAL CONTAINERS
AWAY FROM HEAT & FLAME & I/A/W LOCAL, STATE & FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.